11 13 010 Removing and installing/replacing upper oil sump section (N63)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 11 9 240
See ENGINE - SPECIAL TOOLS (N54, N63) .
Necessary preliminary tasks:
- Drain off engine oil
- Secure engine in installation position
- Lower front axle . See 31 11 506 LOWERING/RAISING FRONT AXLE CARRIER (UNIVERSAL LIFTER) .
- Remove front differential . See 31 50 001 REMOVING AND INSTALLING/REPLACING FRONT DIFFERENTIAL .
- Remove lower oil sump section
- Release FEED AND RETURN LINES on oil filter
- Release holders of supply/return lines on oil sump
- Detach plug from oil pressure switch
- Unclip wiring harness on oil sump
Remove oil filter cover with oil filter (1) with special tool 11 9 240.
Tightening torque: 11 42 1AZ, see 11 42 OIL FILTER AND PIPES
Release screws (2).
Tightening torque: 11 41 1AZ, see 11 41 OIL PUMP WITH STRAINER AND DRIVE
Release bolts in area of line (1).
Release bolts in area of line (1).
Release bolts in area of line (2).
Tightening torque 11 13 2AZ, see OIL SUMP
Release 4 bolts on transmission side.
Tightening torque 24 00 1AZ, see 24 00 TRANSMISSION IN GENERAL
Remove upper oil sump section (1).
Installation:
Free sealing faces of seal debris and clean.
Replace seal.
Modify oil pressure switch if replacing oil sump.
Assemble engine.