11 61 065 Removing and installing/replacing left intake manifold (N63)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 00 0 200
See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
Necessary preliminary tasks:
- Remove complete front panel.
- Remove complete cooling core with condenser . See 17 11 000 REMOVING AND INSTALLING RADIATOR (N63) .
- Remove power steering pump with bracket. See 32 41 037 REMOVING AND INSTALLING/REPLACING POWER STEERING PUMP FOR POWER STEERING GEAR WITH DYNAMIC DRIVE (N63) or 32 41 033 REMOVING AND INSTALLING POWER STEERING PUMP FOR POWER STEERING GEAR WITH ACTIVE FRONT STEERING (N63)
- Remove left injection pipe . See 13 53 205 REMOVING AND INSTALLING/REPLACING LEFT RAIL (N63) .
Detach engine ventilation hose (1).
Unscrew nuts (2).
Tightening torque: 11 61 1AZ, see INTAKE MANIFOLD
Fit special tool 00 0 200.
Release nuts on left and right engine support arms.
Raise engine.
Release throttle valve (1).
Release screw (2).
Tightening torque: 11 61 2AZ, see INTAKE MANIFOLD
Installation:
Replace all profile seals.
Assemble engine and vehicle.
Check intake system for leaks.