13 62 591 Removing And Installing/Replacing Pressure Sensor On Left Intercooler (N63)

Necessary preliminary tasks:

Unclip Bowden cable for engine bonnet/hood actuator from transverse reinforcement (1).

Detach A/C line from holder.

Release screws on left and right.

Tightening torque, see 51 71 4AZ in 51 71 SEALS AND LOOSE BODY PARTS .

Remove cross-brace (1).

Fig 1: Removing Cross-Brace

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Release screws (2).

Tightening torque, see 13 62 7AZ in SENSOR FOR CONTROL UNIT .

Pull pressure sensor (3) out of left intercooler.

Installation:

Replace sealing ring on pressure sensor.

Fig 2: Pulling Pressure Sensor Out Of Left Intercooler

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Now clear the fault memory.