34 41 220 Removing and installing/replacing all handbrake shoes
Special tools required:
- 34 4 000
See BRAKES - SPECIAL TOOLS .
Installation:
- Remove rear brake disc
- Release electromechanical parking brake (EMF)
After completing tasks, adjust parking brake .
Disconnect return springs (1) with brake spring pliers.
Installation:
Return springs (1) must not be overelongated.
Check return springs (1) and replace if necessary.
Return springs (1) must not be mixed up.
Pay attention to installation position of adjustment screw (2).
Apply a thin coat of grease to bush and screw threads,
Refer to Operating Fluids. See BRAKES - OPERATING FLUIDS .
NOTE:
Illustration does not show wheel hub.
Turn clamping pins (1) with special tool 34 4 000 through 90° and disconnect.
Remove brake shoes (2).