65 50 160 Removing and installing/replacing trim for rear cabin monitor display at front and rear

Special tools required:

Important!

Trims may only be replaced in pairs so as to avoid differences in color.

Unclamp trims (1) on both sides with special tool 00 9 340 .

Installation note:

Make sure trims (1) are securely seated in rear cabin monitor trim at front.

Fig 1: Disconnecting Trims Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 65 52 2AZ .

Fig 2: Identifying Rear Monitor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclamp trim for display at rear (1) with special tool 00 9 340 and remove

Fig 3: Removing Rear Panel Display Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully remove trim for display at front (2) and disconnect plug connection (3).

Installation note:

Make sure ribbon cable is securely seated.

Fig 4: Identifying Front Panel Display Screws

Courtesy of BMW OF NORTH AMERICA, INC.