66 53 010 Calibrating reversing camera (from 10/2009)
NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Body repair work at rear end of vehicle
- Adjusting work at tailgate
IMPORTANT:
Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:
To obtain an optimum result, always adhere to the following conditions:
- Vehicle standing level on headlight aiming station
- Correct tire inflation pressure (see label on vehicle).
- Vehicle is free of load
- Rear seat bench is unoccupied
- Do not swap seats during calibration
- Steering wheel in straight-ahead position
- Do not move steering wheel
NOTE:
Also switch on reversing camera by means of PDC button.
Calibration can only be carried out with the BMW diagnosis system.
Use of a special tool is no longer required from 10/2009!
Service functions:
- Complete vehicle
- Driver assistance
- Reversing camera