65 83 570 Removing and installing/replacing CD drive for Car Communication Computer

Special tools required:

12 7 192

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
Risk of damage!
Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and connect to earth/ground.

Necessary preliminary tasks

Remove FRONT TRIM HOLDER FOR CAR COMMUNICATION COMPUTER

Release screws (1), remove CD drive and place to one side.

Installation note:

Ensure correct cable routing.

Fig 1: Identifying CD Drive And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Release screws (1) and remove lid (2) from CD drive.

Fig 2: Identifying CD Drive Lid And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through warranty seal (1) at marked point.

Release screw (2).

Lift side cover out of mounting (3) and carefully place to one side.

Fig 3: Identifying Warranty Seal, Mounting And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove CD drive.

Installation note:

Ensure correct cable routing.

Fig 4: Identifying CD Drive Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Special tools required:

64 1 020

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) !

Necessary preliminary tasks

Remove FRONT TRIM FOR CAR COMMUNICATION COMPUTER .

If necessary, cut through warranty seal.

Raise cover (1) with special tool 64 1 020 all round and remove from Car Communication Computer (2).

Fig 1: Removing Cover Using Special Tool (64 1 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1).

Feed CD drive for Car Communication Computer (2) in direction of arrow out of Car Communication Computer (3) and set down.

Installation:

Ensure correct routing of cables.

Fig 2: Removing CD Drive Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1).

Remove CD drive trim (2) in direction of arrow from CD drive for Car

Communication Computer (3).

Installation:

Ensure correct routing of cables.

Fig 3: Removing CD Drive Trim Mounting Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through warranty seal (1) at marked point.

Release screw (2).

Lift side cover out of mounting (3) and carefully place to one side.

Fig 4: Identifying Warranty Seal, Mounting And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove CD drive.

Installation:

Ensure correct routing of cables.

Fig 5: Identifying CD Drive Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.