65 83 580 Removing and installing/replacing DVD drive for Car Communication Computer (CCC)

Special tools required:

12 7 192

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
Risk of damage!
Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and connect to earth/ground.

Necessary preliminary work

Partially remove CD DRIVE FOR CCC .

Release screws (1) and remove lid (2) with CD drive.

Installation note:

Make sure cables are correctly laid.

Fig 1: Identifying CD Drive Lid And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying CD Drive Lid Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 3: Identifying CD Drive Lid Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Place Car Communication Computer (2) to one side.

Feed out DVD drive and disconnect plug connections (2).

Installation note:

Make sure cables are correctly laid.

Fig 4: Identifying Car Communication Computer And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: There are two versions of the upper plug connection (2) shown in image R65 0986:
Previous version (1): ribbon cable is connected horizontally
Current version (2): ribbon cable is connected vertically

Fig 5: Identifying Ribbon Cable Connections

Courtesy of BMW OF NORTH AMERICA, INC.