65 77 016 Removing and installing/replacing airbag control unit
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
WARNING:
NOTE AIRBAG SAFETY REGULATIONS!
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary work:
- E72: Disconnect both battery earth cables
- DISCONNECT BATTERY NEGATIVE LEAD and cover.
- Remove COMPLETE CENTRE CONSOLE .
- Remove ventilation duct of rear passenger compartment
Unscrew nuts (1).
Tightening torque 65 77 1AZ .
Disconnect plug connections (2).
Installation note:
Make sure ground cable (2) is correctly laid.
If necessary, replace damaged cable shoe on ground cable (2).
Replacement:
Carry out PROGRAMMING/ENCODING .