67 32 600 Replacing fan for front seat surface (comfort seat)
WARNING:
US/CDN front passenger seat (with OC3 mat) only:
If seat cover is defective, seat cover, padding and OC3 mat must be replaced together.
The same applies to a faulty OC3 mat or padding. Both parts can only be replaced together with the seat cover.
New seat cover is supplied with padding, OC3 mat and if necessary seat heating.
After fitting, the OC3 mat must be enabled with the diagnosis system.
Individual parts not available.
If seat cover is defective, seat cover, padding and OC3 mat must be replaced together.
The same applies to a faulty OC3 mat or padding. Both parts can only be replaced together with the seat cover.
New seat cover is supplied with padding, OC3 mat and if necessary seat heating.
After fitting, the OC3 mat must be enabled with the diagnosis system.
Individual parts not available.
Necessary preliminary tasks:
- Remove FRONT SEAT
- Partially remove COVER FOR FRONT SEAT
NOTE:
For purposes of clarity, illustration shows seat padding and seat cover removed.
Lift dividing net (1), pull fan for seat surface (2) out of seat padding (3) slightly and disconnect plug connection behind.
Remove fan for seat surface (2).