51 24 080 Removing and installing/replacing drive for rear lid lock

Necessary preliminary tasks

Security vehicles:

Lever out cover (1), release screw underneath and remove handle (2).

Lever out cover (3) and release screw underneath.

Installation:

If necessary, replace faulty drives (1 and 2).

Fig 1: Identifying Rear Lid Lock Covers And Handle

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect Bowden cable (1 and 2).

Fig 2: Identifying Bowden Cables

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and feed out drive (2).

Tightening torque 51 24 6AZ .

Fig 3: Identifying Rear Lid Lock Drive And Screws

Courtesy of BMW OF NORTH AMERICA, INC.