51 49 080 Removing and installing/replacing cover for loading sill (on rear lid lower section)

Necessary preliminary tasks 

• Remove TRIM FOR REAR LID LOWER SECTION .

Lever out cover (1), release screw underneath and remove handle (2).

Lever out cover (3) and release screw underneath.

Installation: 

If necessary, replace faulty drives (1 and 2).

Fig 1: Identifying Covers And Handle

Courtesy of BMW OF NORTH AMERICA, INC.

Release cover (1) at clips (2) and feed out.

Installation: 

If necessary, replace faulty clips (2).

Fig 2: Disconnecting Cover At Clips

Courtesy of BMW OF NORTH AMERICA, INC.