51 47 128 Removing and installing/replacing trim panel for luggage compartment floor

Push retaining spring (1) to end of gas pressure spring.

Remove gas pressure spring from ball head.

Firmly pull luggage compartment floor (2) towards rear and thereby disengage from hinges (3).

NOTE: Removal is easier the flatter the luggage compartment floor (2) is positioned.

Fig 1: Pushing Retaining Spring To End Of Gas Pressure Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Release screws (1).

Remove hinge (2).

Fig 2: Identifying Hinge And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove mounting plate (2).

Fig 3: Identifying Mounting Plate And Screws

Courtesy of BMW OF NORTH AMERICA, INC.