51 41 000 Removing and installing (replacing) front left or right door trim panel
Special tools required:
Necessary preliminary tasks:
Driver's side only:
- Remove POWER WINDOW SWITCH
Front passenger side only:
- Remove COVER ON DOOR HANDLE
Place the special tool 64 1 020 (as shown) behind the inside door handle securing pin (1).
Lever out rear catches of cover (2).
Open inside door handle (1) while levering out cover (2) further at the back.
Slight up and down movement will release the front catches of the cover (2).
Remove cover (2).
Installation note:
Retaining catches (1) of cover (2) must not be damaged or missing.
Installation note:
Catches (1) and (2) must not be damaged or missing.
Installation note:
Offer up cover (1) to fit and snap into place at the back.
Thumb pressure in handle recess (2) will snap cover (1) into place at the front.
Example OEM formula: value = X - Y2
Driver's side:
Release screws (1 and 2).
Front passenger side:
Release screws (1 and 2).
Unclip door trim panel (1) from clips (2) with special tool 00 9 317 .
Carefully unclip door trim panel (1) at top from retainers (2).
Unhook Bowden cable (1) from door lock (2).
Disconnect all plug connections and remove door trim panel.
Replacement:
- Remove speakers (1). See:
- Remove DECORATIVE STRIP (2)
Installation note:
If necessary, replace faulty clips (1).
Fit all clips with sealing ring.
Make sure clips are installed in correct position.
- Grey clip
- Light blue clip
Installation note:
After assembling the door trim panel proceed as follows:
- Open side window
- Lock with vehicle key
- Check for ease of movement on locking button linkage
- If necessary, align linkage