51 49 080 Removing and installing/replacing cover for loading sill (on rear lid lower section)

Necessary preliminary tasks:

Lever out cover (1), release screw underneath and remove handle (2).

Lever out cover (3) and release screw underneath.

Installation:

If necessary, replace faulty drives (1 and 2).

Fig 1: Identifying Handle And Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Release cover (1) at clips (2) and feed out.

Installation:

If necessary, replace faulty clips (2).

Fig 2: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.