51 47 030 Removing and installing/replacing rear (inside) left or right entrance cover strip

Special tools required:

Necessary preliminary tasks:

Fig 1: Removing Entrance Cover Strip With Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Release expansion rivet (1).

Unclip (2) the entrance cover strip (3) with special tool 00 9 317 .

Pull entrance cover strip (3) up and remove.

Installation:

If necessary, replace faulty clips (1).

Fit entrance cover strip (2) with preinstalled clips (1).

Fig 2: Identifying Entrance Cover Strip And Clips

Courtesy of BMW OF NORTH AMERICA, INC.