51 22 225 Removing and installing/replacing inside door opener of rear left or right door
Necessary preliminary tasks:
- Remove rear DOOR TRIM PANEL
Unhook Bowden cable for release lever:
- Tighten release lever (1).
- Lever out lock (2).
- Detach Bowden cable (3) towards rear/top.
Installation:
For fitting, press release lever (1) fully onto door trim panel.
NOTE:
On initial installation there is no screw in area (A).
If necessary, release screw in area (A).
Release catches (1) and remove door opener (2).
Installation:
Repair screw must be inserted in area (A) when door opener is installed.
Installation:
Catches (1) on door opener (2) must not be damaged.