51 47 491 Removing and installing/replacing rear underbody protection
WARNING:
Scalding hazard!
Tasks should only be carried out on an exhaust system that has cooled down.
Tasks should only be carried out on an exhaust system that has cooled down.
Release screws (1 and 2).
Unscrew nuts (3).
Pull out underbody protection (4) in direction of arrow towards bottom.
Installation:
Ensure correct seating.
Center underbody protection (4) before tightening down screws (1 and 2).
Replacement:
- Modify sheet nuts
Installation:
If necessary, replace faulty metal nuts.