41 61 014 Adjusting Engine Compartment Lid

IMPORTANT: E92, E93, E82, E88 only:
These instructions only apply to vehicles without active pedestrian protection !
Observe separate procedure for vehicles with ACTIVE PEDESTRIAN PROTECTION .

Read contents of BODY, GENERAL .

The BODY GAP DIMENSIONS specified serve as the basis for the adjusting procedure.

Make unpainted surfaces visible by also moving the hinges. Touch these up in the appropriate color.

NOTE: Carry over schematic diagram to the relevant vehicle type.

Loosen screws (1) and (2) on left and right hinges.

Engine compartment lid must be able to be moved.

NOTE: If the adjustment range is not sufficient, release retaining screws of engine compartment lid hinge on body and move hinge.

Courtesy of BMW OF NORTH AMERICA, INC.

Locks and retaining hook must engage correctly.

Adjust engine compartment lid.

NOTE: HEIGHT ADJUSTMENT of engine compartment lid to side wall by means of stop pads.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Height adjustment of engine compartment lid to front wall:

Release screw (1) and remove cover (2).

Height adjustment by turning at closing hooks (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten all screw connections again.

Tightening torque 41 61 1AZ .

IMPORTANT: Check function of retaining hook.