51 71... Removing and installing/replacing radiator seal
WARNING:
Scalding hazard!
Only perform work after engine has cooled down.
Only perform work after engine has cooled down.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle.
Necessary preliminary tasks:
- Remove front underbody protection.
NOTE:
Prior to removing, pay attention to the exact installation position with respect to the adjoining components.
Release screws (1).
If necessary, remove underbody protection bracket.
Release catches (2) and feed out radiator seal (3) towards rear.
Installation:
Catches (1) must not be damaged.