Necessary preliminary work
- Read out fault memory in DME control unit
- Switch off ignition
- Unlock hose on tank venting valve and disconnect
- Remove left CHARGE AIR COOLER
- Carefully press pipe to one side
NOTE:
Solenoid valve (2) controls the intake adjuster.
Solenoid valve (4) controls the exhaust adjustment unit.
Solenoid valve (4) controls the exhaust adjustment unit.
Unlock plug connections of solenoid valves (2 and 4) and disconnect.
Installation note:
Plug connections must snap audibly into place!
Unfasten screws (1 and 3).
Tightening torque 11 36 3AZ .
Pull out solenoid valves (2 and 4).
Installation note: