51 47 Floor trim, luggage compartment and engine compartment trim panels
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2019 BMW M6 Gran Coupe, 2019 BMW 650i Gran Coupe xDrive, 2019 BMW 650i Gran Coupe, 2019 BMW 640i Gran Coupe xDrive, and 2019 BMW 640i Gran Coupe. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - FLOOR TRIM, LUGGAGE COMPARTMENT AND ENGINE COMPARTMENT TRIM PANELS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Roller cover for luggage compartment frame to body | F07 | M8x22 | 17.5 Nm | |
| 2AZ Luggage compartment removable panel hinge on rear luggage compartment to body | F07 | 3.3 Nm | ||
| 3AZ Tail panel cover to transmission cross-member | F07 | 2 Nm | ||
| F15/F85/F86 | 3 Nm | |||
| 4AZ Screw connection, lashing eyes | F07/F11 | 6 Nm | ||
| F06/F12/F13 | 20.5 Nm | |||
| 5AZ Stud, rail cover | F07 | 6 Nm | ||
| 6AZ Screw connection, rail support | F07 | Replace screws | 8 Nm | |
| 7AZ Roller cover for luggage compartment lock to body | F07 | Replace screws | 8 Nm | |
| 8AZ Screen trim, center | F07 | 1.8 Nm | ||
| 9AZ Lock/housing to roller cover for luggage compartment (center) | F07 | 2.3 Nm | ||
| 10AZ Lock to retaining bracket | F07 | 25 Nm | ||
| 11AZ Locking bracket to roller cover for luggage compartment (center) | F07 | 8 Nm | ||
| 12AZ Mounting, cargo cover, to frame, cargo cover | F07 | 12 Nm | ||
| 13AZ Screw connection, underbody protection | F03 | 19 Nm | ||
| 14AZ Load area net cover mounting | F11 | 2.5 Nm | ||
| 15AZ Lashing rail to body | F25/F26 | 12 Nm | ||
| F15/F16/F85/F86 | 20 Nm | |||
| 16AZ Mounting for roller cover | F25 | 7.6 Nm | ||
| F85/F86 | 8 Nm | |||
| 17AZ Battery cover to body | F15/F85/F86 | 3 Nm | ||
| 18AZ Shoulder to body | F15 | 3 Nm | ||
| F85/F86 | 6 Nm | |||
| 19AZ Trim panel, D-pillar bottom to body | F15/F85/F86 | 3 Nm | ||
| 20AZ Trim panel for luggage compartment floor on body | F15 | Flat-head screw M8x18 | 8.5 Nm | |
| Sheet metal screw ST 4, 8x19 | 3 Nm |