34 11 Front Brake
TIGHTENING TORQUE SPECIFICATION - FRONT BRAKE
| Type | Thread | Tightening specifications | Value | |
|---|---|---|---|---|
| 1AZ Brake disc to wheel hub | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M8 | Replace screws. | 16 Nm |
| 2AZ Caliper carrier to swivel bearing | F01, F02, F04, F06, F07, F10, F11, F12, F13, F18 | M12x1.5 | Replace screws. | 110 Nm |
| F03 | M14x1.5 | Replace screws. Attention: Observe 4 phase tightening! Jointing torque Release Jointing torque Angle of rotation |
150 Nm min.90 ° 150 Nm |
|
| 180°± 15° | ||||
| F25/F26 | M12x1.5 | Replace screws. Jointing torque Angle of rotation |
75 Nm 45°10° |
|
| 3AZ Guard plate to swivel bearing | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M6 | Replace screws. | 12 Nm |
| 4AZ Guide bolt (brake caliper to caliper carrier) | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | SW9 | 55 Nm | |
| F07/F06/F10/F11/F12/F13/F18/F25/F26 | SW7 | 30-5 Nm | ||
| F25/F26 | SW8 | 28 Nm | ||
| 5AZ Brake caliper at swivel bearing | F06/F10/F12/F13/M models only | M12x1.5 | Hexagon nut | 95 Nm |
| 6AZ Stud bolt (for brake caliper) in wheel carrier | F06/F10/F12/F13, M models only | Clean the screw thread in the wheel carrier and replace the stud bolt. | 20 Nm |