22 32 001 Replacing rubber mount for transmission mounting

Necessary preliminary tasks:

Remove rear UNDERBODY PROTECTION .
Support transmission with lifter.

Unscrew nuts (1).

Tightening torque 22 32 2AZ .

Release screws (3).

Tightening torque 22 32 3AZ .

Remove gearbox cross member (2).

Remove rubber mount from transmission cross-member.

Tightening torque 22 32 4AZ .

Fig 1: Identifying Gearbox Cross-Member Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Note the installation position of rubber mount (1) relative to transmission cross-member (2).

Arrow shows in direction of engine/front of vehicle.

Fig 2: Identifying Installation Position Of Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Remove rear UNDERBODY PROTECTION .
Support transmission with lifter.

Release screws (1).

Tightening torque 18 20 2AZ .

Detach rubber mount of exhaust system.

Fig 1: Identifying Exhaust System Rubber Mount Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque 22 32 2AZ .

Unfasten screws (2).

Tightening torque 22 32 3AZ .

Remove transmission cross member.

Remove rubber mount from transmission cross-member.

Tightening torque 22 32 4AZ .

Fig 2: Identifying Transmission Cross Member Nuts And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Note the installation position of rubber mount (1) relative to transmission cross-member (2).

Arrow shows in direction of engine/front of vehicle.

Fig 3: Identifying Installation Position Of Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Remove rear UNDERBODY PROTECTION .
Support transmission with lifter.

Release screws (1).

Tightening torque 18 31 6AZ .

Detach rubber mount of exhaust system.

Fig 1: Identifying Exhaust System Rubber Mount Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque 22 32 2AZ .

Unfasten screws (2).

Tightening torque 22 32 3AZ .

Remove transmission cross member.

Remove rubber mount from transmission cross-member.

Tightening torque 22 32 4AZ .

Fig 2: Identifying Transmission Cross Member Nuts And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Note the installation position of rubber mount (1) relative to transmission cross-member (2).

Arrow shows in direction of engine/front of vehicle.

Fig 3: Identifying Installation Position Of Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.