22 32 001 Replacing rubber mount for transmission mounting (ATC 35L)

Special tools required:

Necessary preliminary tasks:

Mount special tools 22 1 042/22 1 041 on transfer box.

Pull out rubber mount with thrust plate 22 1 043 by means of spindle 33 4 460 and nut 22 1 017.

Fig 1: Pulling Rubber Mount With Thrust Plate (22 1 043)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Pay attention to installation position of rubber mount (1).

Fig 2: Identifying Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Bolt special tool 22 1 044 to transfer box.

Insert special tool 22 1 046 with bolt into recesses of rubber mount.

Draw in rubber mount with special tools 33 4 466 and 33 4 465.

Installation note:

Auxiliary installation material - low-surface-tension water.

Do not coat rubber mount with grease.

Fig 3: Drawing Rubber Mount With Special Tool (33 4 466)

Courtesy of BMW OF NORTH AMERICA, INC.