22 31 001 Replacing rubber mount for gearbox mounting (N13)

Necessary preliminary tasks:

Unscrew nuts (1).

Tightening torque 22 32 2AZ .

Release screws (3).

Tightening torque 22 32 3AZ .

Remove gearbox cross member (2).

Remove rubber mount from transmission cross member.

Tightening torque 22 32 4AZ .

Fig 1: Identifying Gearbox Cross-Member Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Note he installation position of rubber mount (1) relative to transmission cross-member (2).

Arrow shows in direction of front of vehicle.

Fig 2: Identifying Installation Position Of Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.