23 14 567 Removing/replacing zero gear sensor (335i)

WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2018 BMW 320i xDrive, 2018 BMW 320i, 2017 BMW 320i xDrive, 2017 BMW 320i, and 2016 BMW 335i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

IMPORTANT: After installing the zero-gear sensor, it is necessary to teach in the position of the zero-gear sensor again.
Calibration is carried out using the BMW Diagnosis System "Service Function" (Learn/record zero-gear sensor).

Necessary preliminary tasks:

Remove REAR UNDERBODY PROTECTION .
Remove complete exhaust system . See REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM , REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM or REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM .
Remove heat shields.

Unfasten screws (2).

Tightening torque 26 11 5AZ .

Fig 1: Removing Rear Underbody Protection

G04794211

Courtesy of BMW OF NORTH AMERICA, INC.

Support transmission with special tools 23 4 050 , 00 2 030 .

Fig 2: Supporting Transmission With Special Tools (23 4 050)

G05758007

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 18 20 2AZ .

Detach rubber mount of exhaust system.

Fig 3: Identifying Screws

G10103092

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (3).

Tightening torque 22 32 3AZ .

Lower transmission.

Fig 4: Identifying Screws

G10103444

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on zero gear sensor.

Unfasten screws (2).

Remove zero gear sensor.

Installation note:

Replace screws (2).

Tightening torque 23 14 2AZ

Fig 5: Identifying Zero Gear Sensor Plug Connection And Screws

G05502400

Courtesy of BMW OF NORTH AMERICA, INC.