23 14 560 Removing/replacing zero gear sensor
WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2018 BMW 320i xDrive, 2018 BMW 320i, 2017 BMW 320i xDrive, 2017 BMW 320i, and 2016 BMW 335i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After installing the zero-gear sensor, it is necessary to teach in the position of the zero-gear sensor again.
Calibration is carried out using the BMW Diagnosis System "Service Function" (Learn/record zero-gear sensor).
Calibration is carried out using the BMW Diagnosis System "Service Function" (Learn/record zero-gear sensor).
Necessary preliminary tasks:
- Lower transmission.
Tasks are described in Removing TRANSMISSION .
Disconnect plug connection (1) on zero gear sensor.
Unfasten screws (2).
Tightening torque 23 14 2AZ .
Remove zero gear sensor.
Installation note:
Replace screws (2).