67 62 020 Removing and installing/replacing flat motor for rear left or right power window unit: Notes

Necessary preliminary tasks:

Release screws (1) and detach flat motor (2) from power window unit.

Installation:

Retaining pins (3) must not be released!

Fig 1: Identifying Power Window Unit Flat Motor, Retaining Pins And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: To ensure tension-free installation of flat motor, observe the specified screwing sequence.

Tighten first screw (1), then screw (2) and finally screw (3).

Tightening torque 67 62 1AZ .

Fig 2: Identifying Power Window Unit Flat Motor And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.