62 11 280 Removing and installing/replacing instrument panel
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION
).
Necessary preliminary work:
- Disconnect BATTERY EARTH LEAD
- Move steering column completely towards rear
- If necessary, tape over trim and instrument panel to protect against damage
Insert special tool 64 1 030 in each case in second slot, on left and right, of instrument cluster (2).
Feed special tool 64 1 030 into clamp (1) and pull downward.
Feed out instrument cluster (2) in direction of arrow.
Disconnect plug connections (1) and remove instrument cluster (2).
Installation note:
Retaining tabs (1) of dashboard (2) must be exactly seated in mountings of dashboard.
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .
Check values for Condition Based Service (CBS) and correct if necessary.
If necessary, adjust HEAD-UP DISPLAY .