31 35 000 Removing and installing/replacing front anti-roll bar

Necessary preliminary tasks: 

• Remove FRONT UNDERBODY PROTECTION .
• Remove BOTH ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR .

Release screws (1).

Tightening torque 31 35 1AZ .

Remove anti-roll bar (2) downwards.

Fig 1: Identifying Anti-Roll Bar And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Identifying Anti-Roll Bar Retaining Bracket Nose And Lower Mounting Plate Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Replace screws.

Pay attention to installation location of retaining bracket and mounting plate!

• Nose (1) on retaining bracket must point left in direction of travel.
• Curve (2) on lower mounting plate points to rubber bearing.