52 26 311 Removing and installing/replacing lock for left or right rear seat backrest

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Unclip lock finisher (1) in direction of arrow (2) starting with backrest side section.

Remove lock finisher (1) in direction of arrow (3).

Fig 1: Removing Lock Finisher

G10167560

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs (1) and (2) of cover must not be damaged.

Replace faulty cover.

Fig 2: Lugs

G10167561

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!

Insert plastic wedge from outside between trim (1) and lock.

Carefully lever outer side of trim (1) with plastic wedge upwards out of catch.

Lever inner side of trim (1) with plastic wedge out of catch.

Remove cover upwards.

Fig 3: Inserting Plastic Wedge From Outside Between Trim And Lock

G04792103

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out backrest cover (1) in working area.

Fig 4: Levering Out Backrest Cover

G04792104

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and feed door lock (1) out of rear seat backrest.

Tightening torque: 52 26 06AZ .

Fig 5: Screws And Feed Door Lock

G04792105

Courtesy of BMW OF NORTH AMERICA, INC.