34 00 009 Checking brakes on test stand
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Check tires for damage
- Check tire treads
- Checking tire pressure
IMPORTANT:
The corresponding system must be deactivated on vehicles equipped with DSC.
The DSC indicator and warning light in the dashboard must light up!
The DSC indicator and warning light in the dashboard must light up!
The brakes must be at normal operating temperature. To do so, gently warm up the brake discs and brake drums while dry by braking the vehicle several times.
IMPORTANT:
Only brake test stands with test speeds of 2.5-6 km/h may be used.
Maximum brake bedding-in time 2 min.
You must observe the regulation contained in the operating instructions of the relevant test stand manufacturer.
Failure to do so may result in damage to the vehicle and the system and also personal injury.
Maximum brake bedding-in time 2 min.
You must observe the regulation contained in the operating instructions of the relevant test stand manufacturer.
Failure to do so may result in damage to the vehicle and the system and also personal injury.