63 99 273 Replacing bulb for turn indicator, front left

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Follow instructions for handling light bulbs (EXTERIOR LIGHTS) .

Unlock and remove cover (1).

Fig 1: Removing Front Bumper Panel Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Turn bulb holder (1) in direction of arrow and remove from headlight (2).

IMPORTANT: Risk of damage due to moisture penetration!
Installation note:
Check seal. Replace bulb holder (1) if necessary.
Comply with INSTRUCTIONS FOR REPLACING THE PROTECTIVE CAP .
Turn bulb holder (1) clockwise to limit position.
Bulb holder (1) must lock correctly.

Fig 2: Turning Bulb Holder

Courtesy of BMW OF NORTH AMERICA, INC.

21W version:

Pull bulb (1) in direction of arrow out of bulb holder (2).

Installation note:

Note BULB TYPE .

Fig 3: Pulling Bulb Out Of Bulb Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Type PY24W:

Turn bulb with socket (1) in direction of arrow and remove from bulb holder (2) toward the top.

Installation note:

Check that bulb with socket (1) and sealing ring (3) on bulb holder (2) are correctly seated.

Fig 4: Turning Bulb With Socket

Courtesy of BMW OF NORTH AMERICA, INC.

Note BULB TYPE .