66 53 170 Removing and installing/replacing control unit for Top-/Rear-/Side-View Camera

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks:

Remove TRIM PANEL FOR PEDAL MECHANISM

Unlock all plug connections and disconnect.

Unlock latch mechanisms (1).

Remove control unit (2) from holder (3) downwards.

Fig 1: Removing Control Unit From Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Guide (1) on control unit (2) must be correctly inserted in corresponding recess on counter support.

Make sure control unit (2) is securely seated.

Fig 2: Identifying Control Unit Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/ENCODING .
CALIBRATE REVERSING CAMERA