61 31 197 Removing and installing operating facility for center console: Overview

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Risk of damage (scratches)

Tools and sharp-edged components can cause scratches.

Protect working area.
Handle tools and components carefully.

Detaching the gearshift lever cover:
- Pull installation frame of gaiter at the sides upwards out of center console.
  
  Fig 1: Detaching Gearshift Lever Cover
  Courtesy of BMW OF NORTH AMERICA, INC.
Removing the operating unit for the center console:
- Adhere to following procedure:
  1. Reach under front section of operating unit for the center console (1).
  2. Press front latch mechanism in direction of arrow and simultaneously raise operating unit for the center console (1) towards top.
  3. Disconnect associated plug connection and remove operating unit for the center console (1).
    
    Fig 2: Removing/Installing Operating Unit For Center Console
    Courtesy of BMW OF NORTH AMERICA, INC.
Installing the operating unit for the center console:
- Clip in the operating unit for the center console.
  
  Fig 3: Removing/Installing Operating Unit For Center Console
  Courtesy of BMW OF NORTH AMERICA, INC.
Installing the gearshift lever cover:
- Press the installation frame of gaiter on the sides and position.
  
  Fig 4: Installing Gearshift Lever Cover
  Courtesy of BMW OF NORTH AMERICA, INC.