61 31 043 Removing and installing roof switch cluster (front)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325

IMPORTANT: Follow notes for handling light bulbs (INTERIOR LIGHTING) .

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Carefully unclip cover (1) with special tool 00 9 325 and remove.

Installation note:

Ensure cover (1) is correctly seated.

Fig 1: Removing Cover With Special Tool (00 9 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock left/right retaining lugs (1) with screwdriver (2) in direction of arrow.

Remove roof switch cluster (3).

Unlock plug connections underneath and disconnect.

Installation note:

Retaining lugs (1) must not be damaged.

Make sure roof switch cluster (3) is correctly fitted.

If necessary, INITIALIZE slide/tilt sunroof.

Fig 2: Unlocking Retaining Lugs With Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Disconnecting the plug connection for the SOS emergency call button results in fault entries in the telephone control unit (restriction in the emergency call system).
After installation, read out fault memory and if necessary delete fault code entry.