61 31 041 Removing and installing operating element for assist system

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 327

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

NOTE: Work shown on the F30 by way of example, deviations in detail are possible in other models.

Carefully release cover (1) from clamps (2) with special tool 00 9 327 .

Disconnect associated plug connection and remove cover (1).

Installation note:

Make sure cover (1) is correctly seated.

Fig 1: Releasing Cover From Clamps Using Special Tool

G10098495

Courtesy of BMW OF NORTH AMERICA, INC.

Remove operating element (1) by releasing retaining clips (2) from cover (3).

Installation note:

Make sure operating element (1) is correctly seated in cover (2).

Fig 2: Identifying Operating Element, Retaining Clips And Cover

G10098496

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Guides (1) and clamps (2) on cover (3) must not be damaged or missing.

Fig 3: Identifying Guides, Clamps And Cover

G10098497

Courtesy of BMW OF NORTH AMERICA, INC.