61 31 008 Removing and installing (replacing) steering column switch cluster

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Move wheels into straight-ahead position and do not alter this position during the repair work.
Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.
Make sure the anti-twist lock locks during removal, the clock spring must not twist until installation.

Necessary preliminary tasks:

Remove STEERING WHEEL

Unclip steering column shroud upper section and lower section (1).

Unfasten screws (2).

Tightening torque 61 31 3AZ .

Remove steering column switch cluster (3) in direction of arrow.

Installation note:

Make sure during installation that the anti-twist lock is positioned correctly on the coil spring cassette.

Fig 1: Removing Steering Column Switch Cluster

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Remove steering column switch cluster (2).

Fig 2: Identifying Steering Column Switch Cluster And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.