61 35 245 Removing and installing (replacing) Smart Opener bottom sensor line (non-contact rear lid opening)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
NOTE:
Work shown on the F30 by way of example, deviations in detail are possible in other models.
Depending on the engine version:
If necessary, release screws (1) on cover (2) and remove cover (2).
NOTE:
Control unit and sensor strip are located on reinforcement of rear bumper panel.
Release screws (1) on bumper panel at bottom rear.
Unlock associated plug connection (1) on control unit (2) and disconnect.
Installation note:
Make sure plug connection (1) is correctly seated.
NOTE:
Shown with bumper panel removed for purposes of clarity.
IMPORTANT:
Risk of damage, do not kink sensor line!
Feed out associated connecting line in area (A).
Reach between reinforcement and bumper panel.
Release sensor line (1) from holder (2) in direction of arrow and feed out.
Installation note:
Make sure sensor line (1) is correctly fitted.
Holders (2) must not be missing or damaged.
Make sure connecting line is correctly laid.