61 35 240 Removing and installing (replacing) Smart Opener control unit (non-contact rear lid opening)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
NOTE:
Work shown on the F30 by way of example, deviations in detail are possible in other models.
Depending on the engine version:
If necessary, release screws (1) on cover (2) and remove cover (2).
NOTE:
Control unit is located on rear reinforcement of bumper panel.
Release screws (1) on bumper panel at bottom rear.
Unlock plug connections. (1) and disconnect.
Reach between reinforcement and bumper panel.
Release control unit (2) at latch mechanism (3) and feed out in direction of arrow.
Installation note:
Make sure all plug connections (1) are correctly seated.
Make sure control unit (2) is correctly seated on latch mechanism (3).
Make sure connecting lines are correctly routed.