61 12 062 Replacing wiring harness on front bumper
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on HANDLING WIRING HARNESSES AND CABLES
.
Necessary preliminary tasks:
- Remove FRONT BUMPER PANEL
NOTE:
Graphic shows the F30 by way of example, deviations in detail are possible in other models.
Depending on equipment specifications following sensors can be installed:
- Ultrasonic sensors.
- Pedestrian protection sensor.
- ACC sensor.
Unlock associated plug connections and disconnect.
Unclip wiring harness from bumper panel in direction of arrow.
Release central connector (4) from latch mechanism and remove wiring harness.
Installation note:
Make sure wiring harness is correctly laid.
Make sure central connector is fitted correctly (4) on bumper panel.