LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> 740Lxi >> Repair and Diagnosis >> External Pages >> Different car >> Section 965 (General Electrical System - Repair - F31) >> 12V Power Socket, Cigarette Lighter >> 61 34... Removing and installing/replacing 12-V power socket

61 34... Removing and installing/replacing 12-V power socket

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

Necessary preliminary tasks: 

Check the equipment dependent sockets that are available.

Cup holder: 

Unclip connector (1) and feed through under center console to power socket (2).

Remove power socket (2) using special tool 61 0 250 . (See last operation.)

Fig 1: Identifying Connector And Power Socket
G09949637Courtesy of BMW OF NORTH AMERICA, INC.

Rear center console trim: 

Remove socket (1) from the center console trim using special tool 61 0 250 . (See last operation.)

Fig 2: Identifying Rear Center Console Trim And Socket
G09949639Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment: 

Open flap in left luggage compartment trim panel.

Put your hand behind the left luggage compartment wheel arch panel.

Detach connector (1) from power socket (2).

Fig 3: Identifying Connector And Power Socket
G09949640Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment: 

Fold up the protective cap over power socket (1).

Fig 4: Identifying Power Socket Protective Cap
G09949641Courtesy of BMW OF NORTH AMERICA, INC.

Luggage compartment: 

Remove socket (1) using special tool 61 0 250 . (See last operation.)

Fig 5: Identifying Socket
G09949642Courtesy of BMW OF NORTH AMERICA, INC.

Pull out 12-V power socket from housing with special tool 61 0 250 until connector is at bottom of light ring.

Fig 6: Removing 12V Socket Using Special Tool (61 0 250)
G06895084Courtesy of BMW OF NORTH AMERICA, INC.

Lever out power socket (1) in direction of arrow with a suitable tool.

Fig 7: Removing Power Socket
G04752819Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanisms (1) with a suitable tool.

Press power socket mounting (2) in direction of arrow out of power socket frame (3).

Installation note: 

Latch mechanisms (1) at socket mounting (2) must not be damaged. Make sure socket mounting (2) is fitted correctly in socket frame (3).

Fig 8: Pressing Power Socket Mounting Out Of Power Socket Frame
G10098579Courtesy of BMW OF NORTH AMERICA, INC.