41 00... Information On Hazards
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Aluminium
Hazards/effects Measures/regulations Repair stage 1 and 2:
No hazards/effectsnone Repair stage 3: (Welding - only E52) - Explosion hazard due to high concentration of fine aluminium dust.
Arising e.g. during straight-through grinding of coated components in the base material and large-surface grinding of bright-finish components.
- Explosion hazard due to swirling up of fine aluminium dust in cavities.
Created by the necessary, thorough cleaning of machining surfaces and tools before and after machining aluminium.
- Avoid high concentration of fine aluminium dust by means of continuous extraction.
- Use explosion-proof exhaust extraction unit
- Do not use compressed air when cleaning the workbay.
- Avoid swirling up dust when cleaning the workbay.
- Spontaneous combustion of fine aluminium dust when ignition and fire sources are drawn in.
E.g.: hot debris, grinding sparks, cigarettes, etc.
- Do not operate ignition and fire sources in the intake area of exhaust extraction unit.
- Explosion hazard due to high concentration of fine aluminium dust.
- Carbon
Hazards/effects Measures/regulations Repair stage 1:
No hazards/effectsnone Repair stage 2 and 3: - Explosion hazard due to high concentration of carbon dust.
Produced when grinding carbon.
- Explosion hazard due to swirling up of carbon dust in cavities.
Created by the necessary, thorough cleaning of machining surfaces and tools before and after machining carbon.
- Avoid high concentration of carbon dust by drawing it off continuously.
- Use explosion-proof exhaust extraction unit
- Do not use compressed air when cleaning the workbay.
- Avoid swirling up dust when cleaning the workbay.
- Spontaneous combustion of carbon dust when ignition and fire sources are drawn in.
E.g.: hot debris, grinding sparks, cigarettes, etc.
- Do not operate ignition and fire sources in the intake area of exhaust extraction unit.
- Explosion hazard due to high concentration of carbon dust.