54 12 117 Replacing seal for glass slide/tilt sunroof lid
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Follow REPAIR INSTRUCTIONS for bonded seals on slide/tilt sunroof
- Open glass lid completely
Start removal at contact edge (rear center):
- Peel off rubber seal
- Clean bonded area
Installation:
Also start at specified point of contact edge for installation:
- Stick on rubber seal in stages
- Establish seal joint
- Press on seal