62 30 010 Removing and installing/renewing head-up display

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

IMPORTANT: Comply with notes and notes on HANDLING OPTICAL FIBRES .
Risk of damage!
Do not scratch lens of head-up display.

Necessary preliminary tasks:

Remove INSTRUMENT PANEL TRIM

Release screw (1) on carrier housing (2) at bottom.

Tightening torque 62 30 1AZ .

Fig 1: Identifying Carrier Housing And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove sound insulation (1) from head-up display (4).

Disconnect plug connections (2).

Release screws (3).

Tightening torque 62 30 1AZ .

Carefully feed out head-up display (4) in upward direction.

Installation note:

Clean lens of head-up display.

Fig 2: Identifying Sound Insulation, Head-Up Display, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust HEAD-UP DISPLAY .

Replacement:

Carry out VEHICLE PROGRAMMING/ENCODING .