35 11 000 Removing and installing (replacing) complete bearing support for foot pedal: Notes

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of work, carry out function check.

Necessary preliminary tasks:

Remove BRAKE SERVO

Release screws (1).

Remove control units from holder (2). Plugs remain connected.

Fig 1: Identifying Control Units Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Installation note:

Replace self-locking nut.

Tightening torque 35 11 2AZ

Remove bearing support (2).

Fig 2: Identifying Bearing Support And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip line (1).

Disconnect plug connection (2).