3.1 Preparation of the surface on the vehicle (series status)
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
- Establish a level bonding surface (e.g. grinding). Do not remove the series primer entirely.
- Do not grind/sand bonding surfaces.
- If necessary, pre-clean bonding surfaces with cavity sealing wax remover.
Clean bonding surfaces with cleaning agent R1.
- Allow cleaned surfaces to dry for approx. 5 minutes.
Bonding surfaces must be completely dry.