37 20 001 Removing and installing/replacing DYNAMIC DRIVE valve block: Notes
WARNING: This page is about a different car, the 2011 BMW 750xi and 2010 BMW 750xi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
Do not draw off hydraulic fluid (risk of contamination).
NOTE:
In all warranty cases you must always provide a fault memory printout, even where there is no fault entry, with the defective component. In addition, the valve block openings must be sealed with the protective caps (of the new part).
Necessary preliminary tasks:
- Partially remove FRONT RIGHT WHEEL ARCH COVER (REAR SECTION)
- Remove RIGHT UNDERBODY PANELLING
Disconnect return line with special tool 13 3 010 .