37 12 012 Carrying out ride height adjustment
WARNING: This page is about a different car, the 2011 BMW 750xi and 2010 BMW 750xi. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ride height adjustment must be carried out after the following work:
- Removal / replacement of ride height sensor or its control rod (only necessary for vehicles with air suspension or vehicles with VDC)
- Replacement of wiring harness
- Replacement of air supply system control unit (F01/F02/F04/F07/F11)
- Replacement of vertical dynamics management control unit
- Replacement of ICM control unit (Integrated Chassis Management)
Connect BMW diagnosis system.
Switch the ignition on.
Carry out ride height adjustment (menu item: "Service function").
IMPORTANT:
Following ride height adjustment, for vehicles with:
- Run Flat Indicator: initialize RUN FLAT INDICATOR
- Tyre Pressure Monitor: RESETTING TYRE PRESSURE MONITOR